As I got some nice feedback from the acrylic clock I recently built. I thought I would put up my home designed pendulum clock. This was created using gearotics and I designed my own escapement using an Arduino and a LED gate. The pendulum is driven by a motor that provides an impulse only on the right to left swing. All other gears were made with a milling machine and a turntable driven by a wonderful controller called Division Master. The time keeping is awful!! But this was my first completely designed clock. With my laser cutter I am now looking to design one with much greater precision. Will post progress.
Regards to all
Jonathan
The Albert
Re: The Albert
Ha, just noticed my foot in the final picture, was standing on the bench to take the picture :D
Re: The Albert
Jonathan;
I Like it, well done. Always nice to see different ways of doing things, A++ for your work and sharing with all of us.
Cheers
Bob
:)
I Like it, well done. Always nice to see different ways of doing things, A++ for your work and sharing with all of us.
Cheers
Bob
:)
Gearotic Motion
Bob
Bob
Re: The Albert
BobL wrote: Jonathan;
I Like it, well done. Always nice to see different ways of doing things, A++ for your work and sharing with all of us.
Well I could not do any of this without your software, it is amazing, thank you for your continued development of it
Jonathan
Cheers
Bob
:)
Who is online
Users browsing this forum: No registered users and 0 guests