I've been playing with screws and noticed the minimum teeth is three. Would like to have a single-tooth gear to lengthen(width) in helix form to make single-start screws. see example in video contest entries....
http://www.youtube.com/watch?v=q5aoTOc3Tak
This program is fun to play with..can see the possibilities!
minimum of one(1) tooth for gear.
minimum of one(1) tooth for gear.
Last edited by Bloy on Mon Sep 27, 2010 1:06 pm, edited 1 time in total.
Thanks,
John M
Sturgeon Bay, WI
John M
Sturgeon Bay, WI
Who is online
Users browsing this forum: No registered users and 2 guests