Page 2 of 4
Re: Galvo Lasers
Posted: Thu Mar 22, 2018 6:44 am
by ArtF
Downside to that I guess is it would add a 200us delay in the laser power stream...
Ill Dwell on it... :)
Art
Re: Galvo Lasers
Posted: Thu Mar 22, 2018 7:55 pm
by tweakie
Hi Art,
That is the way of life - "nothing is ever simple and there is always a catch".
More electronics but could you perhaps introduce an equal delay in the axis movement ?
Tweakie.
Re: Galvo Lasers
Posted: Fri Mar 23, 2018 12:43 am
by ArtF
Ill have to give it more thought. Ironically I put in a laser
delay in Auggie for servos that are slow to react, but I hadnt
considered the inverse.
Art
Re: Galvo Lasers
Posted: Mon Mar 26, 2018 2:28 pm
by ArtF
First try at a single pass 3d , 1.5" round. Took less than a minute.
Not great detail, but its small on pine..
Art
Re: Galvo Lasers
Posted: Mon Mar 26, 2018 6:44 pm
by tweakie
Looking good.
Tweakie.
Re: Galvo Lasers
Posted: Wed Apr 25, 2018 3:10 am
by ElevenCubed
Art,
Do you have a link to your Arduino code used for the DAC signal conversion?
Saw your youtube video and want to give this build a try with my diy style galvo motors.
Thanks
Brian
Re: Galvo Lasers
Posted: Wed Apr 25, 2018 3:14 am
by ArtF
Hi Brian:
I hadnt posted it yet. It is attached to this post though. Let me know if you have
any trouble with it, I cant recall if I modified any system libraries as tweaks to make it
work faster.
I havent cleaned it up and documented it yet, so its a bit messy.. :)
Art
Additional files for arduino
Posted: Sun Nov 18, 2018 3:02 pm
by ArtF
Hi :
The following zip contains a new winterrupts.c required for compiling the code in the previous post.
Also a wiring list for the arduino is included.
(Archival post)
Art
PWM post scaling device
Posted: Mon Dec 31, 2018 3:10 am
by ArtF
Hi:
This is a post for archival purposes. I discussed earlier in this thread the posability of using an arduino
to better control my lasers power for photos. I did make on from an arduino Due and an LCDShield 2.0,
in which a pwm is fed from Auggie ( or whatever) into the arduino, and a selected scale factor is applied
and sent out another pin.
This means at default power on operation it is set to 100% and simply passes pwm through itself,
however it can be set from 5% to 100% and will scale incoming PWM commands from 0-100% to
100 levels of selected scale power. This allows software limited to 100 slices of power, to have 100
slices of power at any set level by the time it reaches the laser.
I include a photo of the device and the .iso file for the arduino to make one. Its hard to say if
this is usefull for anything other than laser driven by auggie, Im not sure what the granularity
is of other lasesr when set to lower power. If a laser set to 20% simply allows power to be
20 levels instead of a 100 levels of 0 - 20%, this may be usefull to someone. I'll post it here just in case
someone in their searches is in need of a PWM scaler. :)
Art