Page 5 of 9
Re: Auggie Early posts
Posted: Fri Nov 27, 2015 9:26 am
by Ya-Nvr-No
Shows circle patterns can be called and displayed on the screen as the axis's are driven to position based on a couple of changes to the variables.
https://youtu.be/FhC2MN7Sprk
Re: Auggie Early posts
Posted: Fri Nov 27, 2015 10:06 am
by ArtF
I hadnt thought of that..well done.!
Art
Re: Auggie Early posts
Posted: Mon Dec 07, 2015 3:29 am
by Alanb6448
Hi everyone,
Please help me clear up a confusion. Is Auggie part of the latest release of gearotic 2 (the 2.30050 I downloaded the other day) only I cannot seem to find it in there. If so how do I enable it? I have just completed my version of an open builds OX machine running off a pokeys57cnc card and would love to give it a try from gearotic. I have a few of my own programs I designed for Ornamental turning that I would like to have a go at converting.
Alan
Re: Auggie Early posts
Posted: Mon Dec 07, 2015 3:40 am
by ArtF
Hi Alan:
Its not yet released, but I expect by Xmas a beta version will be released. Ill likely
post more information over the next couple of weeks.
Art
Re: Auggie Early posts
Posted: Mon Dec 21, 2015 7:23 am
by GlennD
Art
Which pin are you using for the PWM output?
Looking at it pin 22 looks like the most logical.
Just making sure.
Glenn
Re: Auggie Early posts
Posted: Mon Dec 21, 2015 7:59 am
by ArtF
Glen:
Unknown as yet, motion is done, but IO is yet to be implemented..next few weeks will tell...
Art
Re: Auggie Early posts
Posted: Mon Dec 21, 2015 8:41 am
by GlennD
Art
Thanks for the reply.
Look like with the free eagle i am out of room anyway, so will have to be a second board.
I should have the gantry moving on Wednesday, yea for vacation time.
Still not sure if i am going to run my G540 or the Chinese stepper drives, hence the configuration.
Thanks
Glenn