I still have to envision the hour and minute sprockets and chains
Sorry about the sideways video, but I have it cramped into a corner
Ticker phase of clock project
-
- Old Timer
- Posts: 64
- Joined: Tue Feb 18, 2014 5:45 am
Ticker phase of clock project
- Attachments
-
[The extension has been deactivated and can no longer be displayed.]
Re: Ticker phase of clock project
Awesome!
Feels good to watch it doesnt it? :)
Art
Feels good to watch it doesnt it? :)
Art
-
- Old Timer
- Posts: 64
- Joined: Tue Feb 18, 2014 5:45 am
Re: Ticker phase of clock project
Its the worry about whether it will work at all first, then putting the weight on and setting the beat. Then watching it tick and experimenting with pendulum bob weights. AND finding out that there's still a lot of finishing work to be done before it runs like it should.
The next phase is to get it running at least 24 hours without stopping. I have to check the alignment of the sprockets and figure out how thick the teeth should be. I used Gearotic to develop the sprocket design, but used BobCAD/CAM (not recommended by me) to do the machining. The tooth form to me looks a little fat at the base after machining so I think that's the main issue.
Once I have it running reliably, then I have to figure out how to extend the arbor on the 3rd or 4th wheel to get the drive for the hour and minute hands. Might have the hands on two different drives. More to figure out!
Steve
The next phase is to get it running at least 24 hours without stopping. I have to check the alignment of the sprockets and figure out how thick the teeth should be. I used Gearotic to develop the sprocket design, but used BobCAD/CAM (not recommended by me) to do the machining. The tooth form to me looks a little fat at the base after machining so I think that's the main issue.
Once I have it running reliably, then I have to figure out how to extend the arbor on the 3rd or 4th wheel to get the drive for the hour and minute hands. Might have the hands on two different drives. More to figure out!
Steve
Who is online
Users browsing this forum: No registered users and 21 guests