STL Import into Cura are ten times larger than intended
Posted: Sun Jun 14, 2015 11:54 pm
Gearotic STL output module works very well.
But I did notice that the scale of the project imports into Cura at ten times larger than actual size. It's not a big problem shifting one decimal to re-scale, but I was just checking in to see if anyone else had the same experience. - all best!
But I did notice that the scale of the project imports into Cura at ten times larger than actual size. It's not a big problem shifting one decimal to re-scale, but I was just checking in to see if anyone else had the same experience. - all best!