GearHeads Corner
September 21, 2020, 05:17:19 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]
  Print  
Author Topic: Bits from Bytes (BFB) 3D Printer firmware update  (Read 1384 times)
0 Members and 1 Guest are viewing this topic.
Dan Mauch
Full Member
***
Posts: 109


View Profile
« on: May 02, 2020, 12:24:36 PM »

 I bought the subject printer back in 2011. It works fine except recently when I use Axon to convert a stl file to 3d gcode I been getting checksum error when loading it into the machine. I thought the problem was with the USB stick but made an image of it on another usb stick and it was the same. I then thought it was the pc so I installed Axon on another PC and also got the checksum errors when loading on the machine. BFB was bought out by 3D systems but they don't provide any support. I also tried the education group where I purchased the machine but they could not give me any help. The USB stick has  two files for updating the firmware. One is called setup.exe and the other is a hex file. I theorized that I need to connect my a pc to the 3d printer using a usb cable. I also in the 3d printer cursored over to the window for UPDATE but On the PC  I get the device not connected error. Any suggestio ns would be appreciat e so that I can installed updated firmware.
Logged
Mooselake
Hero Member
*****
Posts: 634



View Profile
« Reply #1 on: May 02, 2020, 05:09:46 PM »

What happens if you use Prusa Slicer to generate the gcode?  I found some comments saying it will take gcode from other slicers, which have changed a lot in the last 10 years.

I'd consider abandonin g the old controlle r if a different slicer doesn't work, might be more than bit rot.  RAMPS controlle rs are pretty cheap, but I'd consider going to an SKR E3 mini if you think it would fit.  Otherwise Ender 3 Pros are a couple hundred bucks and likely a much better printer, it's V2 is on preorder or something like that and the original will probably start dropping in price if it hasn't already.

Kirk
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!