GearHeads Corner
April 02, 2020, 05:24:17 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]
  Print  
Author Topic: Looking for help choosing/designing gear set(s) to prototype product  (Read 87 times)
0 Members and 1 Guest are viewing this topic.
SHartman
Newbie
*
Posts: 1


View Profile
« on: March 25, 2020, 01:31:11 PM »

Hi Gearheads,

I'm looking for someone with lots of gear knowledge, especiall y with bevel gears, to advise/consult on a project I have. Would like guidance on what type of gears will be best for my applicati on, and then possibly to design or select those gears from existing products.

I'm building a simple consumer product which will be hand operated. A wheel rolling on the ground will rotate the primary gear at about 120 rpm. I believe there may be 2 good options to achieve my goal:
Primary gear 1 would spin a smaller pinion on a shaft to a second gear, which would spin a second pinion. Desired output speed is between 4,000-9,000 rpm.
Primary gear 1 could be a hub (with internal planetary gears if useful/needed), driving a belt to a second gear, which would spin a second pinion. Same goal of 4,000-9,000 rpm.
Plane from gear 1 to pinion 2 will be a 90 degree shift (vertical to horizonta l) with about a 12" span. Max diameter of gear 1 & 2 will be around 8".

One of these options, or a combinati on of may work, or an entirely different arrangeme nt may be needed/best. That's where I'm looking for expertise . What type of arrangeme nt, and what type of gears. It could be a transmiss ion of some type to get the speeds I'm looking for in the easiest most efficient way possible.

My goal for the gears is to be efficient as possible with reasonabl e cost. Low energy loss, low noise, low wear, low maintenan ce. Minimal force will be used, and I believe composite materials should be fine, but I'm not opposed to metal gears if easier/better. Initially I believed Hypoid would be needed and would be the best fit, but I now believe more simple bevel or spiral bevel may be better.

Hopefully this describes the goal I'm trying to achieve well enough. I'm limiting full disclosur e of the project without an NDA, but can easily provide if you would want/need more detail. Please let me know additiona l questions and I'll answer if I can.

I'm bootstrap ping this project, but willing to pay fair market for consultin g and/or design work. I'm also able to offer an internshi p if a student had the correct skillset & goals and was looking for an internshi p opportuni ty.

Thank you,
Scott
Logged
ArtF
Administrator
Hero Member
*****
Posts: 5618



View Profile
« Reply #1 on: March 26, 2020, 04:08:03 PM »

Hi Scott:

  I dont think Im qualified to design such a thing, a 75:1 transmiss ion would
have propertie s available that make it really tied to the project as to which way to go.
 Theres just too many ways to do that, but in the end the rule is always the fewer
moving parts the better. More so when you need 75:1 step up in speed.
 Hopefully, someone round here has some experienc e in such a device...

Art
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!