GearHeads Corner
September 20, 2019, 01:57:10 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]
  Print  
Author Topic: Spindle Question  (Read 112 times)
0 Members and 1 Guest are viewing this topic.
John T
Hero Member
*****
Posts: 547



View Profile WWW
« on: August 08, 2019, 01:45:49 PM »

Hi Art
This isnít a Gearotic question but maybe you could offer an option/advise.
I just purchased a Koolertro n brushless 500 watt spindle (I am not an electroni cs guy and doubt that I could fix the one they sent me). The motor is great but the motor controlle r has some sort of problem and turns the motor but only slowly.
The voltage out put is only about 15 volts and the motor is rated at 48 volts. I shopped around and found a Knacro power supply that matches the motor specs I could find.

Question Am I likely to fry everythin g in site if I hook these up?
Logged

1% inspirati on 99% try, try again
ArtF
Administrator
Hero Member
*****
Posts: 5380



View Profile
« Reply #1 on: August 08, 2019, 02:28:29 PM »

Hi John:

  Hard to say how they do their 500 watts, if its a 48 volt motor
its likely just a 48volt 10 amp supply with PWM output controlle d
by that pot or constant current controlle d by the pot.
  If your like me and only run the spindle full out, Id just hook
any 48 volt 10 amp supply to it. If it runs fine, off you go.

  Id check carefully though, if a system like that one runs slowly
at 15 volts, thats probably an average voltage your seeing
being switched on and off quickly to keep the motor strong but
slow. Its very likely something your not understan ding on its testing
or hookup. The only referance I can find show them as converted
for mach3, which makes me think its using a pwm output from
mach3 to control it, if misconfig ured, Id expect a low spindle
or no operation .

  If you have a link to any docs for it, let me know , Id be happy
to advise..

Art


Art

 
 
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!